Fault Code |
Condition/Description |
Resolution |
F0 |
Function key stuck |
Replace touch pad or if touch pad is part of the clock, repair the clock (ERC) |
F1 |
System Watchdog Circuit |
Press “Cancel”, if beeping continues after 30 seconds. Repair the main control board (also called clock or ERC) |
F2 |
Heating mode high temperature |
This alarm is activated when the ERC senses a runaway heat condition or when the temperature exceeds “runaway limits”. The ERC will beep until the cancel or another function is selected. If the alarm repeats the F2 code check the oven sensor and wiring after first checking for a stuck relay. If alarm goes away verify the oven will complete a clean cycle without any type of failure |
F3 |
Shorted oven temperature sensor (RTD) |
Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok |
F4 |
Open oven temperature sensor (RTD) |
Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok |
F6 |
EEPROM checksum error |
Repair main control board (also called clock or ERC). |
F7 |
Door lock enabled above temperature |
Check the door lock switches and wiring |
F8 |
Door locking switch |
Check the door lock switches and wiring |
PRP |
Probe Circuitry failure |
Defective robe or check for condensation in probe receptacle area |